PWM to PPM signal converter module

ThePWM to PPM encoder - signal converter module allows you to connect up to 8 PWM channels from a radio receiver through this converter, getting a PPM signal output with 1 signal cable for connection to the flight controller (not including plus and ground).

• Compatible with Pixhawk, APM
• The PPM signal is similar to SBUS and XBUS in its method of operation and 1 cable connection, however it has a slightly lower data rate compared to SBUS.
• The default software is from 3DR, version v2.3.16 is installed, suitable for multirotor systems, airplanes and wings. If you update it yourself, the module may not work correctly!

Connection

• By default the module is powered through the flight controller, not powered from the receiver
• By soldering a jumper on the board, it is possible to use power for the receiver from the signal conversion module.

• Number of channels: 8
• Output signal: PPM SUM × 1 / MUX × 1
• Dimensions: 28 x 19 x 5mm
• Weight: 5.7g (with wires)

• 1 x PPM encoder board
• 1 x Cable to DF13 10-pin receiver on one side and 8 standard servo connectors
• 1 x DF13 PPM cable 3-pin on one side and 1 standard servo connector