ThePWM to PPM encoder - signal converter module allows you to connect up to 8 PWM channels from a radio receiver through this converter, getting a PPM signal output with 1 signal cable for connection to the flight controller (not including plus and ground).
Features
Compatible with Pixhawk, APM
The PPM signal is similar to SBUS and XBUS in its method of operation and 1 cable connection, however it has a slightly lower data rate compared to SBUS.
The default software is from 3DR, version v2.3.16 is installed, suitable for multirotor systems, airplanes and wings. If you update it yourself, the module may not work correctly!
Connection
By default the module is powered through the flight controller, not powered from the receiver
By soldering a jumper on the board, it is possible to use power for the receiver from the signal conversion module.
Features
Number of channels: 8
Output signal: PPM SUM × 1 / MUX × 1
Dimensions: 28 x 19 x 5mm
Weight: 5.7g (with wires)
Accessories
1 x PPM encoder board
1 x Cable to DF13 10-pin receiver on one side and 8 standard servo connectors
1 x DF13 PPM cable 3-pin on one side and 1 standard servo connector
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Reviews and discussions
There are no messages yet. Leave your message first.
Registration