• Home
• Store
• Electronic FPV components
• Other

-0%

×

Baseboard initialization board when Init Ctrl falls

Price:41 609 uah with VATPrice in USD:999.00

Bonuses will be issued for this product upon purchase

Read more

Brand: FlyModSKU 18140

• v1.4. 100pcs

Select the option!

Out of stock

Notify when available

Description

FPV drone drop initialization board with support for remote control. FLYMOD Init Ctrl.

Features.

• Possibility to install a 20mm piezo detector with built-in amplifier for additional detection in case of a fall.
• Opening of both LOAD contacts through a combined switching sequence
• Check of mandatory values when powering up the initiation board
• Quick installation without the need for soldering on the board side, all silicone mounting cables are included and have a key for secure fixation

Specifications.

• Power supply voltage: 5-6V
• Control signal: PWM
• Switching channel values and modes:
  1. 900-1400us - standby mode, zero position
  2. 1450-1790us - mixing mode, with a delay timer of 15 seconds (blue LED blinks slowly), switching to full mixing (blue LED is constant)
  3. >1800us - manual activation and power supply to the LOAD load (provided that the full arming has occurred)
• LOAD output: voltage is the same as the board power supply
• Status LEDs:
  • Green - board power supply
  • Blue - charge status identification
  • Red - output to LOAD
• Dimensions: 32mm x 22mm
• Weight: 8g (without wires)

Connections.

• Power and control: Main, red 5-6V, black GND, yellow Servo signal (connected to the flight controller)
• Sensor ports: J5 connector - dry contact for closure(Dry sensor)
• Output: LOAD - JST connector

Warning. The board will not start if there are no appropriate conditions (error mode with a fast blinking blue LED):

• The control signal is not in the zero position (the remote control is switched off or the activation switch is not in the first position)
• Shorted sensor wires (connector J5)

Photos