The third version of the Mamba MK controller series, the Diatone Mamba F722 MK3 flight controller, despite the removal of the function of changing settings via WiFi, now has a number of other features and improvements.
Important fixes
Added I2C bus
When connected via USB, receiver and OSD settings can be saved
Increased solder pads
LED signal selection (when Mamba LED system is available)
BEC short circuit protection
TVS 30V instant high voltage protection
Upgraded anti-interference cable
USB Type-C interface
Gyroscope uses independent Low Dropout Regulator and reduces interference from ripples
Note:
STM32F722 generates a lot of heat, so leave at least 5mm on both sides of the FC to ensure good air circulation
Caution, please check the pinout of the LED modules to be connected, it may be different from the one used on this controller.
Specifications
Processor: STM32F722RET6 32Bit 216MHz
Gyroscope: MPU6000
Barometer: Yes
OSD: AT7456E
Black Box: 16Mb
UART: 6 ports
F.Port: Yes
ESC telemetry: yes
RSSI: yes
Power indicator: yes
Built-in LED controller 2812: I have, BF LED/MB LED
Smart Audio: yes
RSSI: yes
I2C: yes
Squeaker: supported
Input Voltage: 3-6S Lipo (12.6-25.2V)
Short circuit protection: yes
BEC:
5V/3A (system power).
5V/3A (LED)
9V/3A
3.3V/0.5A
Firmware: BetaFlight
Target: MAMBAF722_I2C
Mounting Diagram: 30.5 x 30.5mm, M3
Dimensions: 38 x 39 x 7.5mm
Weight: 9g
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: DiatoneSKU 16569
Reviews and discussions
There are no messages yet. Leave your message first.
Registration