Naze32 10Dof rev5 flight controller with barometer and compass for Multicopter

Improved version of the Naze32 10Dof rev5 controller, has a built-in pressure sensor (barometer) for altitude control flights and a compass for Headless mode flights. Works on CleanFlight\BetaFlight firmware.

• Modern 32-bit STM32F103C8T6 processor
• Built-in voltage sensor (up to 6S)
• MS5611 barometer
• HMC5883L Compass
• Controller connection and configuration via Micro USB
• Telemetry output
• Built-in FrSky telemetry output with inverter
• Up to 8 inputs from receiver. Supports PPM connection over one wire (FrSky, etc.).
• 8 outputs to motors or servos
• Choice of different quadcopter frames: Quad/Hexa/Tri/Bi/Y4/Y6/Octo
• Very bright indication LEDs
• 2000 degree/per second 3-axis MEMS gyroscope + accelerometer MPU6050
• Squeaker/boozer connection directly to the board

• Board version: rev5
• Power supply: 5 Volt
• Dimensions: 36x36 mm
• Weight: 5.3g (with soldered connectors 7.3g)

• Naze32 10Dof flight controller
• Pin connectors for soldering to the board
• Cable for radio receiver

Controller comes with unsoldered pins.