FlyDuino 's famous KISS F303 multirotor flight controller, long favored by top pilots for its ease of setup and flight quality. Suitable for a variety of flight styles from freestyle to racing.
Features
The controller does not require global customization, engineers created a clean code for clear control and general operation of the controller with KISS GUI software and KISS ESC speed controllers, as well as customize the PID to suit your flying style.
Compact, lightweight and low profile board layout with high quality contact pads for direct soldering of contacts.
Modern 32 bit F303 processor with high data update rate and Looptime. This means that the controller monitors and reacts even faster to changing conditions.
Support for tricopter, quadcopter, and hexacopter.
Support for SBUS receivers via hardware inverter, as well as support for PPM.
Recommended firmware: KISS GUI or Betaflight.
The controller is updated via DfuseDemo.
If you do not see the correct device in DfuseDemo, most likely you have a driver conflict and the following should be done:
The first USB power-up should be done with the BOOT button pressed (you can release the button after power-up).
Next you need to download and open Zadig program from http://zadig.akeo.ie/.
Select Options > List All Devices in the context menu of the program.
Select STM32 Bootloader device from the drop-down list.
Click "replace driver" or "install driver".
All, the controller is ready to use and flash, you just need to turn off/on the USB in the usual way.
Reviews and discussions
There are no messages yet. Leave your message first.
Registration