Matek F722-HD DJI Flight Controller

Name: Matek F722-HD DJI Flight Controller
Brand: Matek
SKU: 15024
Price: 1883 UAH
Availability: OutOfStock
Rating: 4.5 (47 reviews)

Price:1 883 uahPrice in USD:44.99

Brand: MatekSKU 15024

Out of stock

Notify when available

Description

The Matek F722-HD flight controller is designed for direct connection to a DJI FPV Air digital system. Since this FC is designed for digital FPV systems, it does not have an analog OSD module. With 6 UARTS, 10 PWM outputs, MPU6000 and BMP280 barometer, this is a great flight controller for quickly and easily assembling your drone to a DJI system. Compatible with BetaFlight and Inav firmware.

Features

Processor: 216MHz STM32F722RET6
Gyroscope: MPU6000 (SPI)
Barometer: BMP280 (I2C)
Blackbox: 32MB flash memory (SPI)
OSD: support external DJI / FrSkyOSD digital OSD, analog OSD not built into MAX7456
UARTS outputs: 6 with built-in inversion
Softserial_Tx option: 1
Dshot / PWM outputs: 10
I2C: 1
ADCS: 4 (VBAT, Current, RSSI, AirSpeed)
SH1.0 8pin connector: 2 (Vbat / G / Curr / Rx3 / S1~S10)
SH1.0 6pin connector: 1 (for DJI FPV Air Unit)
LEDs: 3
- Operating status: blue, red
- 3.3V indicator: red
Switchable 8V output
PWM camera control: yes
TR / SA VTX control: yes
WS2812 LED strip: supported
Beeper: supported
RSSI: supported
Analog airspeed sensor: supported
Digital air speed sensor: supported
Input Voltage:: 9~36V (3~8S LiPo)
BEC: 5V 2A, (max. 3A)
BEC: 8V 2A, (max. 3A)
LDO 3.3V: max. 200mA
Battery voltage sensor: 1:10 (scale 110), no built-in current sensor
Firmware: BetaFlight
Target: MATEKF722HD (MTKS)
INAV Target: MATEKF722PX
Mounting scheme: 30.5 x 30.5mm, Φ4mm, with spacers Φ3mm
Dimensions: 36 x 36 x 5 mm
Weight: 6.5g

Accessories

1 x Matek F722-HD flight controller
6 x silicone spacers from M4 to M3
1 x SH1.0 8pin 5cm cable
2 x SH1.0 8pin connectors
1 x SH1.0 6pin to GH1.25 8pin 8cm cable

Recommendations

In BetaFlight firmware, when using the FrSkyOSD module, enable FrskyOSD on Uart6 in the BF 10.7 or later configurator
In BetaFlight CLI mode, enter "resource SERIAL_TX 11 A02" if you want to use the TX2 panel as softserial1_TX.
In the INAV firmware on Uart6, FrSskyOSD is enabled by default, replace it with the DJI FPV VTX protocol