Flip32 10Dof - analog controller Naze32, has a built-in pressure sensor (barometer) for flights with altitude control, as well as compass for flights in "headless mode" (Headless mode)
It can be flashed with the standard CleanFlight firmware for Naze32.
The pins are already soldered into the board. Supplied with case.
Features
Modern 32-bit STM32F103CB processor
Built-in voltage sensor (up to 6S)
MS5611 barometer
HMC5883L Compass
Controller connection and configuration via Micro USB
Telemetry output
Built-in FrSky telemetry output with inverter
Up to 8 inputs from receiver. Supports PPM connection over one wire (FrSky, etc.).
8 outputs to motors or servos
Choice of different quadcopter frames: Quad/Hexa/Tri/Bi/Y4/Y6/Octo
Very bright indication LEDs
2000 degree/per second 3-axis MEMS gyroscope + accelerometer MPU6050
Squeaker/boozer connection directly to the board
Features
Power supply: 5 Volt
Board dimensions: 36x36 mm
Weight: with sealed connectors 7.3 g
Accessories
Flip32 10Dof flight controller
5 x servo cable to connect to the receiver
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Reviews and discussions
There are no messages yet. Leave your message first.
Registration