• Home
• Store
• Electronic FPV components
• Flight controllers

-20%

×

SP RACING F3 EVO V2.0 flight controller for collector multirotor systems

Price:545 uah with VATPrice in USD:12.8816.10

Bonuses will be issued for this product upon purchase

Read more

SKU 10694

Archival goods

This item is no longer supplied

Out of stock

Notify when available

Description

Introducing the mini version of the SP RACING F3 flight controller for micro multirotor systems on collector motors with the modern F303 chip that allows you to fly like a racing quad.

Features

• Allows you to connect up to 6 brush motors (up to 10A per channel)
• Supports CleanFlight, BetaFlight firmware.
• Tiny size and weight
• Supports SBUS, PPM, DSM receivers
• Support 1-2S system power supply (selectable by jumper, default is 1S, schematic in the picture below)
• Serial port UART2, UART2, UART3, with external power output up to 500mA (e.g. for connecting FPV system, radio receiver or small LED light)
• Built-in battery voltage sensor and buzzer output

Features

• Name: SP RACING F3 EVO
• Chip: STM32F303CCT6
• Accelerometer: MPU6500
• Dimensions: 22mm x 32.5mm
• Thickness: 1.2mm
• Weight: 3g

Receiver connection

• SBUS - connected in UART2, to pins +5V, GND, and RX2 (SBUS signal). In the configurator tab, in the ports should be checked SerialRX on UART2, as well as in the configuration tab select SBUS connection RX_SERIAL.
• PPM - connected to the connector UART2, to pins +5V, GND, and RX2 (PPM signal). In the configuration tab, in the receiver settings to select RX_PPM.
• DSM - connected directly soldered into the DSM interface to the pins at 3.3V, GND, RX3. In the ports should be set SerialRX3 to UART3

Setting for CleanFlight

For correct operation of the controller and collector motors it is necessary to write the following command"set motor_pwm_rate = 1000" in the command line (CLI) of CleanFlight or BetaFlight, then execute the command"save" to save the settings.

Photos