• Home
• Store
• Electronic FPV components
• ESC speed controllers

-0%

×

Spedix IS25 25A 2-5S 4-in-1 speed controller

Price:1 346 uah with VATPrice in USD:31.69

Bonuses will be issued for this product upon purchase

Read more

Brand: SpedixSKU 14173

Archival goods

This item is no longer supplied

Out of stock

Notify when available

Description

The Spedix IS25 4-in-1 Speed Controller is an affordable 25A rated solution for assembling a 3" mini quadcopter and maximizing its performance! Benefit from lighter overall weight, significantly less wiring, and faster assembly time in a compact 20x20 mounting configuration. Fits easily into even a 2-inch frame.

Features

• High reliability is achieved through PCB design and quality control during its manufacture. Eliminated the possibility of internal breakage during manufacturing, greatly improving reliability and survivability
• Took pilots' installation requirements into consideration by limiting the height of parts on the PCB to 1.6mm. With this design, it makes the flight tower low-profile and prevents interference between wires, ESC and flight controller
• Potential interference between the struts and electronic parts was also taken into account in the design. Fragile parts are located far away from the mounting holes
• Silicone ring spacers can isolate the struts and ESC and prevent the PCB and electronic parts from being exposed to gaps during a crash.
• The 20 x 20 mounting holes are compatible with most 2" and 3" quadcopters
• The product comes with practical accessories. The package comes with 3 different spare 1mm JST-SH 6p, 8p, 10p connectors. Users can easily assemble any necessary connector to match the required connection port to the flight controller
• Comes with a special clip to secure the wires to the frame

Features

• Input Voltage: 2-5S LiPo
• Continuous current: 25A
• Peak current: 35A ≤10sec.
• BEC: no
• Current sensor: Yes
• Firmware: BLHeli_S
• Support protocols: PWM, Oneshot125, Oneshot42, Multishot, Dshot 150/300/600.
• Dimensions: 29 x 32 x 6.5mm
• Mounting holes: 20 x 20 mm
• Diameter of mounting holes: 3.7 mm (M3 spacers included)
• Weight: 7g

Accessories

• 1 x Spedix IS25 25A 4in1 ESC
• 1 x 10cm red and black 16AWG power leads with XT60H
• 5 x M3 damper spacers
• 1 x 25V 330uF capacitor
• 2 x 1mm JST-SH 8-pin connectors
• 3 x spare 1mm JST-SH 6p, 8p, 10p connectors
• 5 x plastic wire hooks with 3M Velcro

Recommendations

• If using 5S power supply, it is recommended to solder the supplied capacitor
• The scale of the ammeter must be set to 200 for the current sensor to work

Photos