JHEMCU ExpressLRS RX24T 2.4G Receiver

JHEMCU RX24T 2.4G ultra-compact radio control receiver based on ExpressLRS firmware for FPV drone installation

• ISM Type: 2.4G
• Frequency Range: 2400 to 2500MHz
• Processor: ESP8285
• RF Module: SX1280IMLTRT
• Maximum receive refresh rate: 500Hz
• Minimum receive refresh rate: 25Hz
• Operating voltage: 5V
• Peak Gain: 3.16dB
• Target ELRS: BETAFPV Lite 2400 RX
• RX24T: Half-wave dipole omnidirectional T-shaped antenna
• Size: 11 x 18 x 3mm
• Weight: 0.6g (without antenna)

1. After the receiver is connected to the flight controller, connect the USB to power the flight controller. After the first USB connection, disconnect the USB as soon as the LED on the receiver goes out. Repeat the operation twice. When the USB is connected a third time, the LED will flash twice and the receiver will go into bind (bind) mode.
2. Once the 2.4G ELRS module and radio hardware are properly connected, copy the ELRS.LUA file to the SD card in the radio hardware, SD Card/Scripts/tools directory, and then run ELRS.LUA for the bind operation
3. After successful binding, the LED on the receiver will be on continuously and a telemetry signal can be received at the same time.

LED indication

• Double blinking LED: binding mode.
• Slow flashing: No signal from the TX module.
• Steady on: successful reception of the transmit signal
• Fast flashing: WiFi update mode

• 1 x JHEMCU RX24T 2.4G receiver
• 1 x T-antenna
• 1 x wire set