UHU Super Glue Control is an instant one-component adhesive based on cyanoacrylate. Ultra-fast and extremely strong liquid adhesive with Direct Stop technology, which makes it very easy to control the application of the right amount of adhesive to the surface. The adhesive does not spread, has a suction back effect and is easy to apply. Due to its consistency, the adhesive is able to penetrate even small corner gaps and joints. In addition, the adhesive is moisture resistant and items glued with UHU Super Glue Control can be washed in the dishwasher.
Ideal for small area gluing. Glues almost all hard and flexible materials such as porcelain, ceramics, wood, metal, cork, felt, fabric (check first for suitability), rubber, many plastics such as rigid PVC (polyvinyl chloride), ABS (acrylonitrile butadiene styrene, impact resistant styrene), PS (polystyrene), acrylic resin (Plexiglas), polycarbonate (Makrolon). Only partially suitable for glass (the bond becomes brittle over time, causing it to weaken).
The adhesive is not suitable for polyethylene, polypropylene, foam, silicone compounds, PTFE, styropor, textiles and leather products.
Characteristics
Type: instant
Color: transparent
Max. temperature: +82°C
Max. strength: after 12 hours
Volume: 3g
Recommendations
Do not use at temperatures below + 10°C. The adhesive responds best to a humidity of 50-70%
Cyanoacrylate adhesives harden very quickly from the presence of moisture (such as air humidity, wet skin, sweat, skin grease, tears). Therefore, care should be taken during use, especially with children and contact with skin and eyes. But even without treatment, cyanoacrylate adhesives will dissolve naturally over time
Instructions
The materials to be glued should be clean, dry and degreased. The best way to achieve this is to wipe the parts several times with a suitable solvent, such as acetone (if it is suitable for the material - check first!). For metals and metal alloys, roughening the surface with sandpaper, sanding or brushing is usually sufficient
To pierce the membrane, place the cap on the tip of the tube and turn it firmly clockwise. Unscrew the cap to open the applicator. Do not press on the tube while piercing it
Apply the adhesive directly from the tube, using the nozzle, in a thin layer to one of the surfaces (too much adhesive will slow down the curing process). Quickly join the two surfaces together. Depending on the amount of glue applied and the material, the glue will polymerize within 60 seconds into a synthetic resin and bond the two pieces very firmly together. When gluing in low humidity, the curing time can be shortened by briefly breathing on one of the parts to be assembled. The best bonding results are achieved at room temperature. Major reactive surfaces accelerate the curing of the adhesive, acidic surfaces (e.g. wood, ceramics, porcelain, leather) slow it down
After use, wipe the tip with a dry cloth and cap the tube.
The adhesive joint can be separated by heating up to 180°C, long-term exposure to water or acetone.
In case of skin contact, wash with warm soapy water. In case of contact with eyes or mouth, keep eyes or mouth open and rinse with plenty of water. Seek medical attention if necessary. Due to the fact that cyanoacrylate adhesives give off special vapors, it is recommended that the room be well ventilated when using relatively large quantities. Keep out of the reach of children
Store in a dry, cool, non-freezing place. Storage at temperatures below + 5 °C (in the refrigerator) ensures maximum shelf life.
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: UHUSKU 15543
Reviews and discussions
There are no messages yet. Leave your message first.
Registration