One of the most popular and affordable radio equipment for controlling quadcopter and other flying models. It is possible to use the open source firmware OpenTX.
Features
Mode: Mode 2
Number of channels: 8 - ppm channels / 9 pcm channels
Display:128*64LCD
Model Type:Helicopter / Airplane / Glider
Models in memory:8
Stick Layout (Modes):1 -4
Modulation type:ppm/ pcm
Sub-trimmer:Yes
Simulator Interface:Yes
Beep:Yes
Voltage control:Yes
Powered by 8 AA batteries or LiPo battery of suitable size and voltage
Note: The "SWITCH ERROR" error means that one of the switches is in the wrong position (the correct position is all the way back) when you turn on the transmitter. This is not an error.
Equipment
Transmitter - Turnigy 9x9Ch
HF module - Turnigy RF9X-V2
8-channel receiver - Turnigy 9X8C-V2.
How to bind the receiver that comes with the equipment:
Install the jumper from the kit into the penultimate channel 9 connector of the receiver (note, the label on the receiver may mistakenly say to install it into the last, 10th connector).
Connect power to the receiver through the connector of any other channel.
The red LED located under the receiver label will start blinking.
Make sure the transmitter is set to PPM mode in advance. Press and hold the Bind button on the back of the transmitter module.
Turn on the transmitter.
After a few seconds, the red LED on the receiver will stop blinking.
Turn off the transmitter.
Disconnect power from the receiver.
Remove the jumper from the channel 9 connector.
Connect power to the receiver (LED off).
Turn on the transmitter, the LED on the receiver lights up steadily.
The receiver is connected and ready to be mounted on the model.
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: TurnigySKU 10225
Reviews and discussions
There are no messages yet. Leave your message first.
Registration