T-MOTOR F30A V2 - ultra light and efficient speed controllers with the new digital Dshot protocol, the smoothness of motor operation is now at a new level.
Compared to the V1 version, the size of the heat sinks on the regulator has been increased for better heat dissipation.
Features
Mini size, ultra light weight with 30A power.
Dshot - New digital data transfer technology provides minimal latency, allows full customization and flashing of the ESC through the flight controller, immediately after installation. No calibration required.
Compatible with digital data communication protocol: Dshot150, Dshot300 and Dshot600.
Fully compatible with other modern data exchange types: 1-2ms support, Oneshot125 (125-250us), Oneshot42 (41.7一83.3us) and Multishot (5-25us).
The BLHeli_S firmware is a more improved code based on the regular BLHeli. It is specially designed to work with hardware PWM. BLHeli_S speed controllers are based on hardware PWM with 36KHZ update rate, realizing very smooth and quiet control of motorless motors. Also active braking (damped light) is always enabled by default.
Cooling radiator
Characteristics
Current: 30 Amps (peak load up to 40A at 10 sec)
BEC: not available (OPTO)
Firmware: BLHeli-S
Bootloader: BLHeli-S (update via two wires on the signal cable)
Main chip: EFM8bb21f16G
Oneshot125 (125-250us)
Oneshot42 (41.7-83.3us)
Multishot (5- 25us)
Power Support: 2-4S Lipo
Dimensions: 26 x 13.5 x 5mm
Weight: 7g (with wires)
Accessories
1 x T-Motor FPV 30A V2 2-4S ESC BLHeli S Dshot controller
songsovered, LittleBee 30A ESC BLHeli-S надежные, отличаются в поддержке аккумов до 6S, Dshot на них тоже можно шить но нужно их самому модифицировать. Регуляторы T-Motor F30A, сразу поддерживают максимум до 4S и шьются сразу на Dshot вплоть до Dshot 600, так же поддерживают все аналоговые протоколы.
Reviews and discussions
Registration