New generation three-axis suspension for video stabilization of GoPro 3, 4, Eken H9, Sjcam, Xiaomi action cameras.
Features
Utilizing 72MHz STM32F103RC processor provides high speed system performance
Dual gyroscope and accelerometer sensor will ensure high quality stabilization
Has 7 built-in PWM channels
3 AUX interfaces
Suitable for GoPro 4, 3, 2 and other action cameras of similar size (camera weight 50-120g)
Possibility to install Bluetooth to customize and adjust PID parameters (there is a place to solder bluetooth module HC-06)
Features
Maximum tilt on Pitch and Roll axes is 25° on Yaw axis 90°
Motor type: motorless, 2206 - 1pc, 2804 - 2pc.
Firmware version: o323bgc-release-v070
Working Voltage: 3-4S (11.1-16.8V)
Operating current: 350mA
Power Connector: JST
Dimensions: 80 x 80 x 100mm
Weight: 180g
Build Version: 1.30
Firmware version 090
How to set up
Install the camera on the pendant (be sure to install the camera, otherwise you can disable the pendant itself), then apply power from 11.1 to 16.8 volts, wait about 20 seconds (do not move the pendant so that it initializes correctly in all axes), after you hear a beep, it can be used on your aircraft. You can control the angle of the hanger through the PWM channels of the receiver or through the flight controller.
Caution! you must not update or re-flash the firmware in the controller, this may render the unit inoperable.
Warning
Balance the camera so that in the free position without power supply, the camera will stay on the suspension level and balanced.
Do not apply power to the hanger without the camera installed, the hanger will not operate properly
Do not apply power unless the camera and suspension are in a horizontal position
Do not touch the controller's output connectors after applying power, as this may damage the controller.
Reviews and discussions
Registration