• Home
• Store
• FPV systems
• Other

-25%

×

Converter micro HDMI to AV analog video signal for FPV

Price:1 067 uah with VATPrice in USD:25.4633.95

Bonuses will be issued for this product upon purchase

Read more

SKU 10170

Archival goods

This item is no longer supplied

Description

The micro HDMI to AV adapter is designed to convert digital video signal to analog. With it you can easily organize FPV video broadcasting via digital camera with micro HDMI output (e.g. SLR cameras). It is also possible to connect this board to a transmitter and take pictures on command from the radio transmitter. Compatible with Sony A5000 A6000.

HDMI output mode should be set to Auto.

• Dimensions: 10 x 7 x 2cm
• Weight: 11g

Included optical cable to connect Sony A5000 A6000 cameras to shutter control via infrared port.

Instructions:

Specifications:

Micro HDMI to AV Converter with RC Shutter (photo/movie) 3015M

Connector type: input Micro HDMI ; output wires and connectors are not included.
Supported cameras: A5000, gopro3, A6000


Remote control method with 3-position switches:
Position 1 (top position) : take photo
Position 2 (middle position): stop
Position 3 (lower position): video recording
* Special hints:
1.Before the device is powered on (including switch on camera or switch on the receiver), the 3-position switch of your transmitter must be set to "Stop" position (middle position), this is very critical for the device to work properly.
2. When switching from "video recording" to "stop" or from "stop" position to "video recording", you must wait for at least 5 seconds, so as the camera can have enough time to respond to the status change. Switching too fast may cause malfunction of your camera or even damage the video file.
3. This device doesn't support high voltage receiver, the power supply of your receiver must be 4.8V to 6V.


* The card may not compatible with other types cameras other than the types listed.

HINT:
HDMI resolution setting of your camera must be set to "Auto" mode, once change the HDMI resolution setting to "Auto", both the camera and HDMI/AV conversion module must be powered off and re-powered on, you should unplug the module and plug it back again to make sure the new setting will take effect.

Photos