TheMatek F411-WING is a smaller version of the Matek F405-WING flight controller. But smaller size does not mean less functionality, the Matek F411-WING is equipped with many of the basic features of the full-size version, such as: multiple BECs, current sensor, OSD, BMP280 barometer and MPU6000 IMU gyroscope.
The small size (28mm x 41mm) means that the controller can fit in almost any size flying wing. This flight controller will suit small wings with limited space for mounting electronics.
The main differences between the Matek F411-WING and the Matek F405-WING are as follows
No Blackbox logging to SD card
No 12V BEC
No RSSI input
5V BEC with 3A current (F405-WING has 5V BEC for 5A)
2 x UART ports (F405-WING has 6)
1 x I2C port (F405-WING has 2)
Smaller current sensor (78A vs. 104A)
Less current consumption 200mA on 3.3V BEC (F405-WING has 300mA)
Specifications
MCU: STM32F411 100MHz
Accelerometer / Gyroscope: MPU6000 (SPI)
Barometer: BMP280 (I2C)
OSD: INAV OSD with AT7456E chip
Blackbox: no
VCP and 2 x UART ports
Motor outputs: 2
Servo outputs: 5
I2C ports: 1
3 x LEDs for FC STATUS (blue, red) and 3.3V BEC indicator (red)
Built-in inverter for SBUS input (UART1-RX)
PPM: ST1 board with SoftSerial disabled
SoftSerial on TX1 board: ST1 pad soldered by default
Battery Voltage Sensor: 1:10 (scale 1100)
WS2812 Led Strip: Check
Buzzer: Check
RSSI: No
Firmware: iNAV
Target: MATEKF411
Mount: 24 x 24 mm, hole diameter 2mm
Dimensions: 41 x 28 x 10mm
Weight: 7g (12g total with bottom board and M2 standoffs)
PDB
Input voltage range: 6.5 ~ 30V (2 ~ 6S LiPo) with TVS protection
Outputs for ESC: 2
Current sensor: 78A, 3.3V ADC, scale 423
BEC 5V output
Designed for flight controller, receiver, OSD, FPV camera, buzzer, LED module, GPS module, AirSpeed
Continuous current: 2A (max. 3A)
BEC Vx output
Designed for servo drives
Adjustable voltage: 5V by default, 6V by jumper
Continuous current: 3A, (max. 4A)
BEC 3.3V output
Designed for Baro / Compass and Spektrum RX module
Brand: MatekSKU 13832
Reviews and discussions
Registration