iFlight iPeaka 35A 3-6S 4 in 1 speed controllers with BEC on 5V / 12V BLHeli_S / Dshot

The iFlight iPeaka 35A 4-in-1 speed controllers with peak current up to 50A will more than meet the growing high current needs of today's motors. The ESC is based on the EFM8BB21 microprocessor with a frequency of 48MHz. There are 6 5x6mm MOSFET transistors on a 3oz copper PCB. Most ESCs use standard 3.3x3.3mm transistors, but compared to them, the 5x6mm MOSFETs have much better heat dissipation and lower resistance. Also on the board are 5V / 1.2A and 12V / 2A power supplies.

• New BusyBee2 microprocessor with 48MHz frequency, support up to 500k eRPM.
• BLHeli_S firmware with support for DSHOT, Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us) protocols. Automatic detection
• Hardware PWM driver at 36kHz
• Built-in current sensor up to 150A
• Compatible with a wide range of motors and KVs
• Efficient regenerative braking / active braking
• Can be used with 6S batteries

• Constant current: 35A
• Peak current: 50A (10 sec)
• Power supply: 3-6S
• Microprocessor: EFM8BB21, 48Mhz
• Built-in current sensor: 150A
• 4PWM input
• Current and voltage output
• BEC: 5V 1.5A / 12V 2A
• Firmware: BLHeli_S
• Protocol Support: Oneshot / Multishot / Dshot
• Mounting Dimensions: 30.5x30.5mm
• Supports fading light
• PCB - 4-layer printed circuit board Blind Pole - 3 oz Pour
• Mosfet: N-channel
• Size: 42 x 40 x 7mm
• Mounting Holes: 30.5 x 30.5mm
• Weight: 15.5g

• 1 x iFlight iPeaka 35A 4 in 1
• 1 x XT60 connector
• 1 x cable set
• 1 x English manual