Happymodel EPW6 receiver with ELRS protocol, frequency 915MHz m 6 channels. These receivers are used on flying wings and airplanes that do not need a flight controller and are controlled via the receiver and servos.
Happymodel EPW6 is flashed via CrossFire protocol pins - RX / TX (PWM3 / PWM2).
Specifications
RF frequency: 915MHz (FCC)
Chips: ESP8285, SX1276
Antenna connector: IPEX MHF1/U.FL
PWM: 6 outputs
Telemetry power: <17dBm
Receiver protocol: PWM or CRSF
Input voltage: 5V DC (pin "+")
Default firmware version: ExpressLRS V2.0.0
Firmware update: via UART or WiFi
Firmware target:
DIY_900_RX_PWMP (factory default firmware) for PWM protocol
HappyModel_RX_ES900_RX for CRSF protocol
Size: 18.5 x 16mm
Weight: 1g (without antenna)
Accessories
1 x Happymodel ExpressLRS EPW6 900MHz receiver
1 x 915MHz antenna
1 x 868MHz antenna
3 x 6-pin 2.54mm male connectors
Receiver Tethering Procedure
Apply power to the EPW6 RX, wait for the green LED on the RX to turn off, immediately turn off the power, and then repeat the above steps again. When the RX turns on for the third time, the green LED will start flashing twice, indicating that the RX has entered binding mode
Enter the ELRS.LUA V2.0 menu on your radio and then press BIND. If the binding was successful, the green LED will be on continuously
Receiver LED values:
A lit LED indicates that the binding was successful or a connection has been established
Double flickering LED means that the LED is in binding mode
Slow blinking LED indicates no signal from the TX module
Fast blinking LED means that the receiver is in WiFi access point mode and you can update the RX firmware by visiting the browser page 10.0.0.1 (password: expresslrs).
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: HappymodelSKU 16690
Reviews and discussions
There are no messages yet. Leave your message first.
Registration