The Spedix IS35 4-in-1 Speed Controller is an affordable 35A rated solution for assembling a 3" mini quadcopter and maximizing its performance! Benefit from lighter overall weight, significantly less wiring, and faster assembly time in a compact 20x20 mounting configuration. Fits easily into even a 2-inch frame.
Features
High reliability is achieved through PCB design and quality control during its manufacture. Eliminated the possibility of internal breakage during manufacturing, greatly improving reliability and survivability
Took pilots' installation requirements into consideration by limiting the height of parts on the PCB to 1.6mm. With this design, it makes the flight tower low-profile and prevents interference between wires, ESC and flight controller
Potential interference between the struts and electronic parts was also taken into account in the design. Fragile parts are located far away from the mounting holes
Silicone ring spacers can isolate the struts and ESC and prevent the PCB and electronic parts from being exposed to gaps during a crash.
The 20 x 20 mounting holes are compatible with most 2" and 3" quadcopters
The product comes with practical accessories. The package comes with 3 different spare 1mm JST-SH 6p, 8p, 10p connectors. Users can easily assemble any necessary connector to match the required connection port to the flight controller
Comes with a special clip to secure the wires to the frame
Features
Input Voltage: 2-5S LiPo
Continuous current: 35A
Peak current: 45A ≤10sec.
BEC: no
Current sensor: Yes
Firmware: BLHeli_S
Support protocols: PWM, Oneshot125, Oneshot42, Multishot, Dshot 150/300/600.
Dimensions: 29 x 32 x 6.5mm
Mounting holes: 20 x 20 mm
Diameter of mounting holes: 3.7 mm (M3 spacers included)
Weight: 7g
Accessories
1 x Spedix IS35 35A 4in1 ESC
1 x 10cm red and black 16AWG power leads with XT60H
5 x M3 damper spacers
1 x 35V 330uF capacitor
2 x 1mm JST-SH 8-pin connectors
3 x spare 1mm JST-SH 6p, 8p, 10p connectors
5 x plastic wire hooks with 3M Velcro
Recommendations
If using 5S power supply, it is recommended to solder the supplied capacitor
The scale of the ammeter must be set to 200 for the current sensor to work
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: SpedixSKU 14174
Reviews and discussions
There are no messages yet. Leave your message first.
Registration