Diatone MAMBA Flash-Bang SW401 LED board with 4 super bright controllable RGB LEDs. The kit comes with 4 strips with 100mm cables that have a pin connector on one side and tinned solder ends on the other.
The LEDs require a 5V power supply, ground and a signal source to operate.
This module differs from SW601 not only in the number of LEDs, but also in the absence of pin connectors. Instead, there are solder pads on the board.
Note:
When installing on a carbon frame, make sure that the module board is insulated from contact with the carbon to avoid possible short circuits
antonkoba, Самим дорожкам под фазы не важно какое напряжение, там просто проводник. А если речь о светодиодах, то это стандартные WS2812B которые питаются от 5В.
0
You need to be registered or authorized users to leave messages. Registration
Reviews and discussions
Registration