Diatone Mamba F722APP flight controller fully repeats all the features of the previous version Diatone Mamba F722S, but the main change is the replacement of Bluetooth module with a more reliable and faster WiFi connection. With the SpeedyBee App mobile application you can control any settings of the flight controller without the need to connect to a PC.
The Diatone Mamba F722S is used in the Diatone Mamba F722APP MK1 flight stack, together with the Diatone Mamba F50Pro 4-in-1 speed controller.
Features
Bluetooth has been replaced with a more reliable WiFi connection
With USB connection you can save receiver and OSD settings
Added I2C pad group (SCL SDA)
Added Dual-Way TX inverter serial port
Added 2812 LED switch to disable LEDs
Improved LED module connection interface
USB Type-C interface
Optimized pin pad layout
Note:
STM32F722 generates a lot of heat, so leave at least 5mm on both sides of the FC to ensure good air circulation
Caution, please check the pinout of the LED modules to be connected, it may be different from the one used on this controller.
Specifications
Processor: STM32F722RET6 32Bit 216MHz
Gyroscope: MPU6000
Barometer: none
OSD: AT7456E
Blackbox: 16Mb
UART: 6 ports
ESC Telemetry: RX6
LED indication:
blue and orange for FC status
green BEC 9V
white BEC 5V
red BEC 3.3V
Built-in LED controller 2812: Yes
WiFi: SpeedyBee app
Smart Audio: yes
RSSI: yes
I2C: yes
Squeaker: supported
Input Voltage: 3-6S Lipo (12.6-25V)
Short circuit protection: yes
BEC:
5V/2A
9V/2A (max. 3A)
3.3V
Firmware: BetaFlight
Target: MAMBAF722_I2C
Mounting Diagram: 30.5 x 30.5mm, M3
Dimensions: 41 x 39 x 7.5mm
Weight: 9g
Recommendations
Enable WiFi function
Photos
Reviews and discussions
There are no messages yet. Leave your message first.
You need to be registered or authorized users to leave messages. Registration
Brand: DiatoneSKU 15540
Reviews and discussions
There are no messages yet. Leave your message first.
Registration