Matek 's M8Q-5883 GPS module with built-in QMC5883L compass. Equipped with a genuine u-blox M8 chip and supports positioning and navigation systems such as GPS/GLONASS/BDS/Galileo/QZSS/SBAS. The integrated GNSS RHCP patch antenna provides the best compromise between performance and small size, especially for mounting in UAV, robot, RC, FPV or other projects. Ideal for use with INAV and other firmware.
Features
72-channel u-blox M8 module with support for multiple geopositioning systems simultaneously, such as L1C / A, SBAS L1C / A, QZSS L1C / A, QZSS L1 SAIF, GLONASS L1OF, Galileo E1B / C
Built-in 3.3V low noise voltage regulator and RF filter for noise blocking
Built-in QMC5883L magnetic sensor
Optional LNA amplifier for optimized performance and front SAW filter for improved noise immunity
Low power consumption
Integrated 15 x 15 mm GNSS RHCP ceramic patch antenna
Rechargeable battery for hot start of GPS module
LED power indicator (red) and time pulse indicator (blue)
Supports INAV / Betaflight / Ardupilot etc.
Features
Chip: u-blox SAM-M8Q
Satellite system support: GPS, GLONASS, Galileo
Maximum navigation update rate:
Single GNSS: up to 18Hz
2 parallel GNSS (GPS and GLONASS): up to 10Hz
Horizontal position accuracy (GPS and GLONASS): 2.5m CEP
Speed accuracy: 0.05m/s
Transmission rate: 9600 bps
Cold Start: 26 sec
Automatic cold starts: 2 sec
Hot Start: 1 sec
Sensitivity
Tracking and navigation: -165 dBm
Data update: -158 dBm
Cold Start: -146 dBm
Hot Start: -155 dBm
Positioning accuracy: 2.5m CEP
Input voltage range: 4~6V
Interface: UART (TX, RX) for GPS SAM-M8Q
Interface: I2C (DA, CL) for QMC5883L Compass
Dimensions: 20 x 20 x 7.5mm
Weight: 7g
Accessories
1 x Matek M8Q-5883 compass module
1 x SH1.0-6P 20cm connector
1 x transparent PVC heat shrink
Recommendations
GPS, GLONASS, SBAS, QZSS enabled by default
Default update rate is 1Hz and baud rate is 9600 bps
Blue flashing LED PPS (1Hz) indicates 3D fixing
The baud rate of 9600 ~ 115200 is supported by INAV / BF / Ardupilot firmware.
Update rate 5Hz with INAV UBLOX protocol
Update rate 10Hz with INAV UBLOX7 protocol
BF does not support GPS and RTH position fixing, GPS Rescue mode is supported in BF3.5 or later versions
The label on the ceramic antenna is proof of ublox authenticity
Подсоединил модуль, горит красным GPS и менял местами rx c tx, ничего не помогает, может руки не отдуда может бракованный попался. Может кто знает решение?
2904_vk, красный светодиод означает работу модуля. Синий должен мигать когда модуль определяет местоположение путём измерения моментов времени, принимаемых синхронизированным сигналом от навигационных спутников.
Brand: MatekSKU 13330
Reviews and discussions
Registration